Indoor (Wall)
PASSIVE INFRARED SENSOR PA-4810E
WIDE ANGLE
WALL MOUNT HIGH QUALITY PASSIVE INFRARED SENSOR
Data Download
Feature
ORIGINAL QUAD ELEMENT + NEW SIGNAL PROCESSING (FUZZY LOGIC)
TAKEX original quad pyroelectric sensor improves sensitivity.
This newly developed original pyroelectric sensor coupled with new Fuzzy Logic provides high catchability.
MIRROR OPTICS AND EASY AIMING SYSTEM
Precise mirror optics and new quad element assure high sensitivity and high reliability.
As mirror and head unit move together, area adjustment does not reduce/blur sensitivity.
TAKEX original view finder assures precise and quick adjustment.
TROUBLE ALARM
Unit monitors the following functions. When a trouble condition is detected, the alarm LED lights and trouble alarm is output.
Unit trouble ... A trouble alarm is triggered when innercircuitry/wiring damaged/broken.
Low voltage ... A trouble alarm is triggered when sensor detects a drop in supply voltage.
Failure to replace ... A trouble alarm is triggered when head unit is not replaced after adjustment is completed.
FINE MOTION DETECTION
Unit can be adjusted from quad element sensing to two twin element by built - in switch for situations where close range detection is desirable.
* Alarm LED disable (ON/ OFF)
* Alarm contact changeover (N.C. / N.O.)
* Sensitivity adjustment (60%, 80%, 100%,1 20%)
ALARM MEMORY
Units contain special circuitry to indicate an alarm has been
activated during armed period.
Especially useful when more than one unit is used per zone.
REMOTE LED CONTROL
Allows the LED to be enabled/disabled via the control panel.
Specification
| MODEL | PA-4810E |
|---|---|
| DETECTION | Passive infrared (Quad : Fuzzy logic) |
| COVERAGE | WIDE ANGLE 12m(40') Max |
| NUMBER OF SENSITIVE ZONE | 18 pairs (72) |
| MOUNTING POSITION | Indoor wall / pillar |
| SUPPLY VOLTAGE | 9.5 to 28VDC (non-polarity) |
| POWER CONSUMPTION | 25mA Max |
| ALARM OUTPUT | Dry contact relay (N.O., N.C. selectable) Reset : approx. 2sec 30VDC (24VAC), 0.25A Max resistive load (protective resistance 3.3Ω) |
| TAMPER SIGNAL | Dry contact (N.C.) Open when cover is detached 30V, 0.1A Max resistive load |
| FINE MOTION DETECTION | 36 pairs |
| ALARM LED | Red LED Warm up : flickering (every 0.5 sec.) Alarm : solid (approx. 2sec.) Memory : continuous solid Trouble alarm : continuous solid (LED disable) |
| ALARM MEMORY | 3 min-Flickering, 47 min-Lighting |
| LED CONTROL | Controls alarm LED indication with terminal L/C |
| TROUBLE ALARM | Unit monitors damage on inner circuitry / wiring (Operate : initiate trouble alarm) Low power voltage : monitors drop in power voltage (Operate : initiate trouble alarm) Failure to replace : monitors failure to replace head unit (Operate : initiate trouble alarm) |
| AMBIENT TEMPRANGE | -10°C to +50°C (+14°F to +122°F) without condensation |
| WIRING | Terminals |
| WEIGHT | 165g (5.82oz.) |
| ADJUSTMENT | Vertically : 20° Horizontally : ±5° |
| ACCESSORY | Fixing screw : 4×30 2pcs. |
The specifications are subject to change without notice.
