Combination Sensor
COMBINATION SENSOR COM-IN-50HF
Coverage: Outdoor 50m
This combination sensor consists of 4-stacked photoelectric beams and 24.1GHz microwave which reinforces the range and stability in severe weather conditions.
Data Download
Feature
TWO FREQUENCIES（H）and（L）SELECTION
Two models are available with different microwave frequencies, COM-IN-50HF（H）and COM-IN-50HF（L）.
INTELLIGENT FUNCTIONS
* Four frequencies selection
Four channel frequency is selectable to avoid crosstalk between sensors which are stacked, in-line, or other configurations which have the potential of spillover transmission from one beam to another.
* Environmental output selector
The environmental signal is initiated when the beam reception level is reduced below an acceptable level by poor weather conditions（dense fog or torrential rain etc.）.
* Alarm memory
Alarm memory LED indicates which sensor issues an alarm when two or more sensors are placed on a zone.
FEATURES OF MICROWAVE SENSOR
* High immunity against hazardous weather such as heavy fog, snowfall or rain.
* Monitor jack output
* Easy alignment
FEATURES OF PHOTOELECTRIC BEAM SENSOR
* 4 synchronized high power infrared beams.
* Sensitivity attenuation LED
Lights when beam level is attenuated, which shows low
sensitivity.
* Monitor jack output
* Protection against frost/dew
As a special hood is attached on sensor cover, beam protection continues without interruption even when the cover is screened by frost or dew.
OTHER FEATURES
* Automatic gain control（AGC）circuit
* Alarm output mode "AND" or "OR" are selectable with a switch.
* Microwave antennae and PE beam lenses adjustable
（horizontally +/-90degrees, vertically +/-10degrees.）
* Tamper output
* Pole or wall mount
* Optional accessories
Specification
| Type | Combination sensor |
|---|---|
| Model | COM-IN-50HF |
| Protection distance | 3.3ft.（1m）to 165ft.（50m） |
| Max. arrival distance | Photoelectric beam : 1500ft.（500m）（tenfold margin distance） Microwave : approx. 330ft.（100m） |
| Infrared beam | LED（pulsed beam by LED） Double modulation |
| Microwave | (L)24.11GHz (H)24.17GHz |
| Detection system | Photoelectric beam and microwave |
| Response time | Photoelectric beam sensor : 50msec. to 700msec.（Variable at pot） Microwave : 40msec. to 300msec.（Variable at pot） |
| Alarm signal | Dry contact relay output 1C Contact action : Interruption time + delay time（approx. 2sec.） Contact capacity : 30V（AC/DC）1A |
| Environmental signal | Dry contact relay output NO or NC Contact capacity : 30V（AC/DC）0.5A |
| Supply voltage | 12 to 30V DC |
| Power consumption | 165mA or less at protection ･ Transmitter : 65mA ･ Receiver : 100mA 200mA or less while beam alignment ･ Transmitter : 65mA ･ Receiver : 135mA |
| Tamper signal | Dry contact output 1b（N/C） Contact capacity : 30V（AC/DC）0.1A |
| Functions | Alignment tone switch, Attenuation LED,Monitor jack, Alarm memory indication, Modulation frequency selectable（4stage）, Environmental check, Automatic gain contro（l AGC）circuit, Frost protection cover, Alarm output selectable（AND/OR） |
| Weight | Transmitter 1850g, Receiver 2000g |
| Appearance | PC resin (Wine red) |
* The specifications are subject to change without notice.
