FLAME SENSOR
FS-1000E Ultraviolet rays detection syste,

Feature

Power supply

The FS-1000E can be powerd from either type-3 alkaline battery ×2 pcs, or an external power source 9～30VDC depending on the application.
Optional power source can be from a long life lithium battery.

External output to a security system

Equipped with a form A (N/O) open collector output, FS-1000E can be connected to a security control panel. Alternatively the output signal
can be used to initiate a warning device e. g. bell, siren etc., when used with an external DC power supply.

Operation set-up by detection timer

The alarm will be activated only when the sensor detects a flame (ultraviolet rays) in accordance with the detection timer. The 3 following detection times are selectable by a slide switch located on the sensor body.
H: 0.2sec. M: 1sec. L: 6sec.

Other functions

･ The internal alarm sounder output is greater than 80dB at 3.3ft. (1m)
in front of the sensor. The internal sounder can be disconnected by cutting a jumper wire if required when using an external DC power supply.
･ Compact design enables FS-1000E to be installed at any location.
Easy separation of the sensor unit from the base simplifies installation and maintenance.
･ Low battery
When using a battery power source, low battery condition is annunciated by an internal buzzer and external LED.
･ Power up
When power is turned on, an alarm sound is activated. If no alarm sound is activated, check the power source.

Specification

Model	FS-1000E
Detection system	Ultraviolet rays detection (Detected wave length 180～260nm)
Detection distance	33ft. (10m) (2.76"(7cm) lighter flame, in front)
Detection angle	Approx. 120degrees (conically)
Detection timer	3 steps changeover by slide switch H (0.2sec.), M (1sec.), L (6sec.)
Power supply	･ Type-3 alkaline battery (LR6)×2 (3V) …accessory ･ Exclusive lithium battery (CR17450E-R-2-CM2)×1 (3V) …optional ･ External power supply 9VDC to 30VDC with polarity
Power consumption	Stand by: 50μA Max. when battery power supply : 5mA Max. when external power supply Alarm: 50mA Max. when buzzer sounds
LED	Indication: Red LED LED Alarm: Flashing every 0.2sec. during off-delay approx. 10sec. Low battery: Light on 0.1sec. every approx. 5sec.
Buzzer	Alarm: Sounds intermittently every 0.2sec. during off-delay 10sec. Low battery: Sound 0.1sec. intermittently every approx, 5sec. Volume: 80dB or more 3.3ft. (1m) ahead (Silent setting is available by cutting internal jumper line)
Wiring	Terminals
Ambient temp. range	+14F to +140F (-10C to +60C) without condensation Battery performance may decrease under +32F (0C) or beyond +104F (+40C)
Installation	Indoor (Ceiling or wall mount)
Weight	Approx. 7oz (200g) including battery (accessory) 1.8oz (50g)
External dimensions	φ4.72" (120mm)×H1.57" (40mm)
Appearance	ABS resin (white)
Accessories	･ Exclusive battery case of Type-3×2pcs, ×1 ･ Type-3 alkaline battery LR6×2 ･ Sensor locking screw φ3×6, ×1 ･ Tapping screw φ4×25, ×2